24 Hour Electronic (8 Set Points)

These time switches provide the same dependable and uncomplicated performance as the T101 mechanical time switch...plus to-the-minute programming for accurate load control and reduced energy costs. Up to 8 set points or events (4 ON/4 OFF) can be preset to automatically repeat on a daily basis. The program can be overridden at any time by placing the selector switch in the Manual position. Two industrial grade “AA” Alkaline batteries provide 3 years minimum program and timing protection.

Specifications

• Case – NEMA 1 – Drawn steel 7-3/4" (19.7 cm) High, 5" (12.7 cm) Wide, 3" (7.6 cm) Deep in gray finish Note: The electronic mechanism snaps into the standard Intermatic time switch case, replacing mechanical mechanisms, if desired.
• Knockouts – Combination 1/2"-3/4" nominal knockouts, one on back and each side of case and two on bottom
• Optional Enclosures – See Time Switch Cases for optional enclosures
• Special Voltages and Cycles – ALL models 50 or 60 Hz
• Switch Rating – Except model ET100C. 30 Amp Inductive/Resistive, 24 / 120 / 240 / 277 VAC 60 Hz; 20 Amp Resistive, 28 VDC; 1 HP 120 VAC 60 Hz; 2 HP 240 VAC 60 Hz; 5 Amp Tungsten, 120 / 240 / VAC 60 Hz; 20 Amp ballast,120-277 VAC 60 Hz. ET100C same ratings for 120 Volt loads only. Models ET105C normally closed contact ratings: 10A Resistive/General purpose, 12 - 277VAC; 10A Resistive/General purpose, 28VDC; 3A Ballast, 120 - 277VAC; 1/4 HP, 120 VAC; 1/2 HP, 240 VAC; 30 LRA; 12 FLA; 275 VA pilot duty, 120 - 240 VAC
• Carry-over – Field replaceable “AA” batteries maintain program and accurate time keeping for 3 years minimum. Up front replacement does not require removal of mechanism or field wiring.
• Wiring Terminals – #18 to #10 AWG wire
• Minimum ON/OFF Times – 1 minute
• Maximum ON/OFF Times – 23 hours 59 minutes